I made my first outdoor sign. I created the design in the silhouette design studio and then cut out the letters onto contact paper. I am only working with a 12×12 mat at the moment, so I cut out the letters and had to measure and place them manually on the board. I painted the top of the board with black chalkboard paint and let it dry all day. I cut everything out and taped it down to see how it would all look before starting to apply the stencil.
I used clear contact paper as my transfer paper.
Then, using the hinge method, I attached the stencil to the wood.
Once everything was placed, I painted over all the letters with black to prevent bleeding. I let that dry for about 20 minutes.
I proceeded with painting the whole board white. I did two coats with 20 minute dry time in between coats.
After I was done painting, I started to peel the contact paper letters off. I did this when the paint was still fairly wet. Just be careful not to smudge the wet paint.
At the end I used polyurethane as a sealer to protect the wood.
I am really happy with how my first sign turned out and am loving the PVPP method for painting.
Make it a great day,
I tried the PVPP (paint, vinyl, paint, peel) on a wood sign this time. As I was looking into it, I found two different ways for the end. The first is to peel the vinyl when the paint is wet, and the second is to peel when the paint has dried. I thought I would do a quick test run to see if I could see a difference or if I preferred a certain way over the other.
I found both worked pretty well for me. For me, I decided I would peel when it was mostly dry, to avoid unwanted smudging of the paint.
I followed Melissa’s tutorial for the method. It is pretty basic. Paint your board the color you want the letters to be. For my sign, that was white. Two coats worked for me.
I cut out my words with my silhouette and attached them to the board with clear contact paper. Then I painted over the letters with white again. This is to help the color not to bleed.
Once that is dry, then paint the whole board your base color, for me that was orange. If you want a full color look, I would recommend two coats. I only did one coat here as I wanted it to be imperfect.
Here is where you would either peel the vinyl right away or wait till it was dry to peel. I waited 20 minutes when it was almost dry and peeled the vinyl off.
The next morning when it was fully dried, I took a piece of sand paper and lightly sanded the whole board. You can also put a layer of sealer on at this time as well.
It really is pretty easy, just has multiple steps. Give it a shot and let me know how it goes!
Make it a great day,